.. SPDX-FileCopyrightText: 2021-2025 BlueALSA developers .. SPDX-License-Identifier: MIT ====== hcitop ====== ------------------------------------- a simple dynamic view of HCI activity ------------------------------------- :Date: July 2023 :Manual section: 1 :Manual group: General Commands Manual :Version: $VERSION$ SYNOPSIS ======== **hcitop** [*OPTION*]... DESCRIPTION =========== **hcitop** provides a dynamic real-time view of activity statistics for each HCI interface. The view is refreshed at regular intervals, and also on demand by pressing a key. To quit the program press the 'q' key, or use Ctrl-C. OPTIONS ======= -h, --help Output a usage message and exit. -V, --version Output the version number and exit. -d SEC, --delay=SEC Set the interval at which the statistics are refreshed. SEC is a number of seconds and may include a decimal point or exponent. COLUMNS ======= HCI The HCI name ("hci0", etc.). BUS The bus name ("UART", "USB", etc.). ADDR The Bluetooth device address. FLAGS Status flags of the HCI. See ``FLAGS`` below. RX Total amount of data received since the HCI was last brought up. TX Total amount of data transmitted since the HCI was last brought up. RX/s Average rate of reception during the last refresh interval. TX/s Average rate of transmission during the last refresh interval. FLAGS ===== An array of flag characters indicating the current status of the HCI. The flags are shown in the following order. The indicated letter appears when that flag is "TRUE", a blank is shown when the flag is "FALSE". U The interface is "Up". N The interface is initializing. R The interface is running. P Page scan is enabled. I Inquiry scan is enabled. A Authentication is enabled. E Encryption is enabled. Q The interface is currently inquiring (scanning) remote devices. X Raw mode is enabled. SEE ALSO ======== ``btmon(1)``, ``hciconfig(1)``, ``hcitool(1)`` Project web site https://github.com/arkq/bluez-alsa